Design of a feeder for miniature components: Investigation into the mode of operation and application of vibrating oblique blade

Hatton, Ronald (1980) Design of a feeder for miniature components: Investigation into the mode of operation and application of vibrating oblique blade. Masters thesis, University of Salford.

[thumbnail of Thesis document] PDF (Thesis document) - Submitted Version
Restricted to Repository staff only
Available under License Creative Commons Attribution Non-commercial Share Alike.

7MB

Abstract

A brief review of work on the automatic feeding of silicon chips using standard electro-magnetic bowl feeders is given
together with a review on a feeding method using a device consisting of a flat, chip-transporting surface and an obliquely
angled, vibrating blade, positioned so as to plough the chips off the moving surface.
A claim that the new method was independent of the coefficient of friction between the chip and blade edge was found to
be incorrect and this modified the previously assumed mode of movement of the chip.
A mathematical analysis, based on the new mode of movement was made and tested for a range of settings on the special test equipment designed and manufactured for the purpose.
Computer predictions of the rate of feed based on the mathematical analysis were consistently low when compared with the
experimental results, the largest discrepancies occurring for sailer angles of blade setting.
Some trouble was experienced with static electricity and larger facsimiles of the chips were made in various materials in an attempt to swamp this, so that reliable values for the coefficients of friction could be used for inclusion in the computer program when atterapting to obtain reasonable correlation between predicted and observed results.
Additional equipment was designed and made in order to obtain values for the coefficients of friction of the chip and the surface, and the chip and the blade edge needed in order to make reasonable predictions of feed rate.
The results showed that small amplitudes and small angles of blade settings gave the best quality feed but that the method would seem to be restricted to square-shaped components. Information from the tests and computer predictions was used to compile a specification for the design of a component feeder which was undertaken.


Repository Staff Only: item control page