Channelled tablets: An innovative approach to accelerating drug release from 3D printed tablets

Sadia, Muzna, Arafat, Basel, Ahmed, Waqar, Forbes, Robert Thomas orcid iconORCID: 0000-0003-3521-4386 and Albed Alhnan, Mohamed (2017) Channelled tablets: An innovative approach to accelerating drug release from 3D printed tablets. Journal of Controlled Release, 269 . pp. 355-363. ISSN 0168-3659

[thumbnail of Author Accepted Manuscript]
PDF (Author Accepted Manuscript) - Accepted Version
Available under License Creative Commons Attribution Non-commercial No Derivatives.


Official URL:


Conventional immediate release dosage forms involve compressing the powder with a disintegrating agent that enables rapid disintegration and dissolution upon oral ingestion. Among 3D printing technologies, the fused deposition modelling (FDM) 3D printing technique has considerable potential for patient-specific dosage form. However, the use of FDM 3D printing in tablet manufacturing requires large portion of polymer, which slows down drug release through erosion and diffusion mechanisms. In this study, we demonstrate for the first time the use of a novel design approach of caplets with perforating channels to accelerate drug release from 3D printed tablets. This strategy has been implemented using a caplet design with perforating channels of increasing width (0.2, 0.4, 0.6, 0.8 or 1.0mm) and variable length, and alignment (parallel or at right angle to tablet long axis). Hydrochlorothiazide (BCS class IV drug) was chosen as model drug as enhanced dissolution rate is vital to guarantee oral bioavailability. The inclusion of channels exhibited an increase in the surface are/volume ratio, however, the release pattern was also influenced by the width and the length of the channel. A channel width≥0.6mm deemed critical to meet the USP criteria of immediate release products. Shorter multiple channels (8.6mm) were more efficient at accelerating drug release than longer channels (18.2mm) despite having comparable surface area/mass ratio. This behaviour may be linked to the reduced flow resistance within the channels and the faster fragmentation during dissolution of these tablets. In conclusion, the width and length of the channel should be carefully considered in addition to surface area/mass when optimizing drug release from 3D printed designs. The incorporation of short channels can be adopted in the designs of dosage forms, implants or stents to enhance the release rate of eluting drug from rich polymeric structures. [Abstract copyright: Copyright © 2017. Published by Elsevier B.V.]

Repository Staff Only: item control page