The influence of piston ring geometry and topography on friction

Morris, NJ, Rahmani, R, Rahnejat, Homer orcid iconORCID: 0000-0003-2257-7102, King, PD and Fitzsimons, B (2012) The influence of piston ring geometry and topography on friction. Proceedings of the Institution of Mechanical Engineers, 227 (2). pp. 141-153.

Full text not available from this repository.

Official URL: http://dx.doi.org/10.1177/1350650112463534

Abstract

This article provides solution for isothermal mixed hydrodynamic conjunction of the compression ring to cylinder liner. This is obtained using the average flow model representation of Reynolds equation based on pressure- and shear-induced flow factors. In particular, the effects of compression ring axial profile along its face-width and surface topography of contiguous solids are investigated. It is shown that ring geometry may be optimized to improve lubrication, whilst care should be taken in order to avoid oil loss or degradation resulting from any loss of sealing. In predicting friction, it is shown that appropriate surface parameters should be used in-line with the state of wear of the ring. For a new ring against a plateau honed liner, boundary friction contribution during the initial running-in wear phase should be predicted according to the average asperity peak heights protruding above the plateau, whilst the plateau height also takes into account the valleys within the surface roughness or grooves created by any cross-hatch honing would be the appropriate measure of topography for worn rings. The main contributions of the article are in providing an analytic solution as well investigation of ring face-width geometry and effect of wear upon friction. However, it is acknowledged that generated heat, inlet boundary starvation and circumferential non-conformity of ring to the bore surface would affect the film thickness and exacerbate generated friction accordingly. These further considerations would require a numerical solution, rather than an analytical one presented here.


Repository Staff Only: item control page